Safety helmet is made out of high impact
resistant ABS or HDPE,it is suitable for safety protect head when
working aloft, with 4 or 6 point suspension, also can choose ratchet or
pin lock, some type of helmet with ventilation provide the maximum in
air circulation for comfort. Safety Helmet ,Hard Helmet,Plastic Safety Helmet,Industrial Safety Helmet Greateagle Safety Products Co., Ltd. , https://www.greateaglesafety.com
2. The equipment is not directly exposed to direct sunlight or other heat sources. 3. The temperature around the equipment should be kept between 15 °C and 30 °C.
4. There is no high concentration of dust and corrosive substances around the equipment.
5. There is no strong airflow in the equipment turnover. When the surrounding air needs to be forced to flow, the airflow should not be directly blown onto the tank.
6. The fluctuation of the power supply voltage of the equipment is ≤±10%.
Salt spray test chamber daily maintenance, how to maintain salt spray test chamber?
1. At the end of each test, it is recommended to clean the equipment test cabinet (including spray chamber, salt solution chamber, preheating water tank and sealed water tank) with clean water to keep the equipment clean.
2. In each test or at the end of the test, the solution of the standard measuring cup should be poured out and cleaned in time to avoid the accumulation of crystals in the salt solution and affect the calculation of the settlement.
3. When cleaning the cabinet, please note:
(1) Protection of the sheath of the temperature sensor.
(2) Protection of glass filters and glass nozzles (cannot use needles or any hard objects to pass through filters or nozzles).
What are the precautions for using the salt spray test chamber?
1. Please confirm the connection of the power supply before the equipment is running.
2. Confirmation of the gas supply system.
3. Confirmation of automatic water supply system.
4. Exhaust hole inspection.
5. Confirmation of the isolation of the sink seal.
6. When preparing the salt solution, please use analytical grade NaCl and distilled water or deionized water to prepare and use it immediately.
7. After each test, the power supply, air source and water source should be cut off to avoid the equipment being in the state of being charged for a long time.
Conform to the standard CE EN 397:2012/ ANSI Z89.1-2009 /GB2811-2007.
Universal slots allow hearing, welding and visor accessories to attach easily.
Salt spray corrosion test chamber operation instructions of Baixin test equipment
1. There must be more than 600mm space around the equipment.