Position the harvesting table on the designated trailer. When parking, ensure that the weight is evenly distributed across both ends of the harvesting table. Avoid placing the central U-shaped beam directly on the trailer's girder. Inspect the structure for any signs of damage or breakage; if found, repair them before proceeding. Before calibration, remove the knife to prevent it from bending during the process. It’s best to take the knife completely off. One person should visually inspect the beam from the tip of the knife to the end of the blade, identifying any deformation. The other person will use chalk to mark the highest point, the second-highest point, and the third-highest point along the beam. Based on these marks, prepare a corresponding number of jacks (5 to 8 tons) and round logs (10 to 15 cm in diameter). One end of each log should be cut into a V-shaped groove, while the other end is flat. The length of the log should be adjusted according to the measured distance during operation. Also, gather some flat iron plates or wrenches for support. Once everything is ready, place a jack and a log diagonally between the highest point of the cutter beam and the square beam above the header. Ensure the V-shaped groove of the log aligns with the corner of the square beam, and the flat end rests on top of the jack. Position the jack so that its base sits on the corner of the cutter beam. Insert the flat iron plate or wrench into the angle between the jack, the cutter beam, and the header plate to stabilize the jack. Slowly raise the jack, causing the knife beam to bend slightly—about 1 to 2 centimeters. Then, lift the second and third highest points one by one. After jacking, let the system rest for 1 to 2 hours before releasing the pressure. Check if the beam is straight. If not, repeat the process using the same method until the desired straightness is achieved. Joints can be replaced if needed during subsequent cold pressing operations. Safety is crucial during this process. Ensure all jacks are stable and positioned properly. Operators should work from the side to avoid being injured by sudden movements of the jacks. Always remain alert and follow proper safety procedures throughout the entire operation.
ChengPeng Pharmaceutical is a trading company with own cooperative factory.We can supply and customize Veterinary Medicine that customer requiry.
The Veterinary Drug market is mixed , so certification, safety and effectiveness are critical.After decades of efforts, Chengpeng Pharmaceutical has own professional team and excellent quality animal medicine cooperation factory.
1. Veterinary Drugs refer to substances (including feed drug additives) used for the prevention, treatment and diagnosis of animal diseases such as livestock and poultry, purposefully regulating their physiological functions, and specifying their role, use, usage and dosage.
2.The dosage form of veterinary medicine refers to the form in which the raw material is properly processed into a safe, stable and convenient application.
Veterinary Medicine,Veterinary Drug,Animal Drug,Livestock Medicine,Poultry Medicine NANYANG CHENGPENG PHARMACEUTICAL CO.,LTD , https://www.chppharm.com
Correction method of cutter beam of large harvester
In addition, we can also provide Animal Drug,Poultry Medicine and Livestock Medicine samples in the first time for customers to test.Veterinary APIs drug/ Premix /Soluble Powder/ Feed Additives /food additives/Chinese veterinary medicine/Herbal extracts is our main business.