Park the harvesting table on the designated trailer. When positioning the table, ensure that both ends of the harvesting frame are evenly supported. Avoid placing the middle U-shaped beam directly on the trailer's girder. Inspect the frame for any signs of damage or breakage, and address any issues before proceeding. Before calibration, remove the knife to prevent it from bending during the process. It’s best to take the knife off completely. One person should visually inspect the blade from the tip to the end of the cutting edge, identifying any deformations. The second person uses chalk to mark the highest point, the second-highest point, and the third-highest point along the beam. Based on these marks, prepare an appropriate number of jacks (5 to 8 tons) and round logs (10 to 15 cm in diameter). One end of each log should be cut into a V-shaped groove, while the other end is flattened. The length of the log should be determined based on the measured distance during operation. Also, gather some flat iron plates or wrenches for support. Once everything is ready, place a jack and a log diagonally between the highest point of the cutting beam and the square beam above the header. Position the V-shaped groove of the log just above the corner of the square beam, and rest the flat end of the log on top of the jack. Place the jack so that its base sits firmly on the corner of the cutting beam. Insert the flat iron plate or wrench into the angle between the jack, the cutting beam, and the header plate to stabilize the jack. Slowly raise the jack, causing the cutting beam to bend slightly—about 1 to 2 centimeters. Then, repeat the process for the second and third highest points. After raising the beam, let it sit for 1 to 2 hours before loosening the jack. Check if the beam is straight; if not, repeat the cold pressing process until the desired result is achieved. Joints can be replaced as needed during subsequent presses. Safety is crucial during this operation. Ensure that all jacks are securely placed and stable. Operators should work from the side to avoid being injured by the jacks slipping outward. Always remain alert and follow proper safety procedures throughout the entire process. A veterinary drug is a medication specifically designed for use in animals to treat or prevent diseases, infections, or other health conditions. These vet drugs may be administered orally, topically, or through injections, and may be used for both domestic and farm animals. animal drugs are regulated by government agencies to ensure their safety and efficacy, and may require a prescription from a licensed veterinarian. Some common types of Veterinary Medicine on line include antibiotics, antiparasitics, anti-inflammatories, and vaccines.Our main products include Veterinary medicine,Premix,Soluble Powder like Albendazole/Amprolium vet drugs,animal drugs,veterinary medicine on line,vet medicine on line NANYANG CHENGPENG PHARMACEUTICAL CO.,LTD , https://www.chppharm.com
TOLTRAZURIL/Closantel Sodium/Doxycycline HCL/IVERMECTIN/TILMICOSIN PHOSPHATE/CARBASALATE CALCIUM/Erythromycin Thiocyanate/Oxytetracycline HCl/Tylosin tartrate/FLORFENICOL/Sulfadiazine/Sulfadimidine/Sulfadimidine Sodium/Cefotaxime sodium/Ceftriaxone sodium/Aspirin/Milbemycin Oxime/ Cefotaxime sodium/Colistin sulfate/
Ceftiofur hydrochloride/Bromhexine Hcl/ Colistin Sulphate/etc