Shenzhen Sunson Tech Co., Ltd , https://www.sunsonkiosk.com
Four Methods for Controlling Edible Mites
Edible mushroom mites are also known as bacillary dysentery, fungal spiders, bacillary dysentery, or maggots, which can be harmful to many edible fungi. Infestation of edible fungi occurs at the initial stage of inoculation with the bacillary dysentery. The hyphae of the inoculated block are first bitten, often without the germination of the mycelium; later, the damage of the mushroom borer will cause the mushroom buds to atrophy and die. Occurrence of mushroom borer on fruiting bodies, discoloration or appearance of holes in the damaged parts, seriously affecting the yield and quality. Mushrooms are small, easy to see with the naked eye, and can easily damage mushrooms. Therefore, it is necessary to prevent and cure mushrooms in time in the cultivation and management of edible fungi. About 7 days after the inoculation of edible fungus, the colored film is placed on the surface of the material for 5 to 10 minutes, and then observed with a magnifying glass close to the side of the culture material. Once it is found small, flat or oval, white or yellow, long When rooting a bristly mushroom, immediately use the following method to kill it. 1, spray killing: with 50% omethoate 1000 times, 1500 times solution of chrysanthemum ester or 500 times Kete special spray killing. Spraying 2 to 3 times continuously with detergent 400 times also has a good killing effect. 2. Rapeseed cake trapping: Spread several pieces of wet cloth on the material surface damaged by mushroom borer, and sprinkle the freshly fried rapeseed cake on the wet cloth. When the tapeworm gathers on the rape cake of wet cloth, remove the wet cloth. You can kill locusts in boiling water for a while. 3, sweet and sour liquid trapping: take 1 part of acetic acid, 1 part of water, 0.1 parts of sugar, mix and drop into dichlorvos, then into a sweet and sour liquid. The gauze or cotton soaked with the liquid is placed on the surface of the material, and the hot-dead pests are removed when the locusts gather on them. Repeat the above procedure until it is clear. 4. Fresh bone trapping: The fresh pork bones are placed on the surface of the bed where the mushroom borer is present. When the locust swarms on it, put the bones in the water for a while to kill the locusts. Repeat several times until there is no flaw on the material surface.