Glucose Syrup,Glucose Syrup Organic,Organic Glucose Powder,Organic Glucose Syrup Organicway (xi'an) Food Ingredients Inc. , https://www.organicwayinc.com
Rotary cultivator sudden failure solution
1. When the tractor is suddenly black and accompanied by skidding during the field operation, the farmer should not panic. This is due to the overload of the rotary tiller. The depth of the rotary tiller is too high and the soil is too hard. As a result, the unit’s speed should be reduced in time. 2. When the rotary cultivator is in the field operation, when there is beating or shaking, because the blade is not installed according to the instructions, the blade should be stopped immediately to check the installation condition of the blade. If the blade is installed wrong, it should be corrected. 3. If the rotary cultivator is in the field operation, if there is noise in the gear box, the operation should be stopped in time. The agricultural hand should get off and check whether the bearing is damaged or not, and whether the gear is missing teeth; if it is caused by the bearing, Should replace the new bearing. 4. In the course of operation, when the rotary cutter blade shaft suddenly stops turning, the agricultural operator should stop the operation in time and check whether the cutter shaft is wrapped around the grass, the bet is serious, or the gear bearing is damaged, causing the bevel gear to have no backlash and other reasons. , weeds should be cleared of dirt, adjust the gap, if the bearing is seriously damaged, new parts should be replaced. 5. When the rotary cultivator is in operation, if metal collision sound and knocking sound are heard, the agricultural operator shall stop the operation and drive the vehicle out of the work site. After getting off the vehicle, first check the looseness of the transmission chain and the collision of the transmission case body. The knocking sounds emitted shall be adjusted; the tightness of the chains shall be adjusted; the blades of both ends of the rotary blade shaft and the left arm or the transmission box will collide with each other after the deformation; the loosening of the blade fixing screws; the application of a hammer to correct the deformation parts, and then tighten the fixing bolts; Only start the tractor into the field.