Edible Fungus Winter Planting Management Three Points

<

The temperature raises the temperature of the mushroom bed and creates suitable conditions for the long mushroom. Cold in winter, pay attention to insulation. The film on the mushroom bed must be covered when the mushroom is peeled off. Pleurotus shed should dilute the covering on the shed. The mushroom shed should be covered with a thin layer of film on the exterior of the shed. The night shed should be covered with shading nets or grasshoppers and other antifreeze. After the above measures are taken, the temperature in the shed can be raised by 5°C to 10°C, which ensures that edible fungi can still produce mushrooms normally in the cold winter.

Humidity and moisture control, warm and cold. Mushrooms, oyster mushrooms, and the growth of the autumn, bacteria rod loss more water, only the original weight of 50% to 60%, at this time should be timely replenishment. Before replenishment, open the shed door for ventilation for 3 to 4 days. When replenishing water, water injection needle can be used to pierce the bacillus. With the pressure of the water pump, the bacterium can absorb enough water in a short period of time to use well water. The principle of water spray is: spray water, mushrooms and more time and more spray, when the mushroom less spray, bud more than spray, harvest time spray. Mushrooms basically do not need replenishment in winter.

Air attention to ventilation, avoid cold wind attacks. After the occurrence of mushroom buds, the air is vigorous. If air does not circulate and carbon dioxide is deposited too much, it will inhibit the formation and growth of fruit bodies. Ventilation should be carried out before and after noon at high temperatures. The time is 10 to 20 minutes. When entering or exiting the shed, they should enter and exit from the south side of the shed to prevent cold and cold winds from attacking.


Quartz Sleeve



We provide quartz sleeve for the uv lamp.


The quartz sleeves are probably the most abused components of a UV system, yet they are one of the most critical for delivering UV rays into the water stream.


Sleeves provide a protective barrier around the lamp so that the lamp can operate at its optimal temperature. For the quartz sleeve to maximize a unit`s performance, both the interior and exterior of the sleeve must be cleaned periodically, even in UV units installed in ultra-pure water systems. All quartz sleeves are susceptible to fouling.

Cleaning frequency of quartz sleeves will be site-specific and directly related to water quality. UV systems that are installed in post-reverse osmosis/deionization (RO/DI) locations will require cleaning much less frequently than units installed on raw water or surface water systems. As a general rule of thumb, a post-RO/DI system should have the quartz sleeves cleaned once a year.


Plan on cleaning quartz sleeves quarterly on post-activated carbon systems and more frequently for hard water applications exceeding 5 grains of hardness.


Standard clear quartz glass tube is high quality purity and automatic controlled fusing furnace

It has the characteristics of high purity,strong resistance,high transmission and accurate dimensions,and the OH content 1-20ppm after air of vacuum baking is available.


Quartz Sleeve

Quartz Sleeve, UV Quartz Sleeve, Ultraviolet Quartz Sleeve

Ningbo Sunfine UV lighting Co.,ltd. , http://www.uvlightings.com