The dicing machine is a general term for machines that are suitable for dehydrated vegetables, quick-frozen vegetable processing plants, soft jelly and other soft foods, and food pickles to process various roots and stems into cubes and cuboid shapes.

Introduction

The dicing machine is a general term for machines that are suitable for dehydrated vegetables, quick-frozen vegetable processing plants, soft jelly and other soft foods, and food pickles to process various roots and stems into cubes and cuboid shapes.

The dicing component consists of a slicing knife, a set of circular cutter shafts and a set of transverse cutter shafts. The conversion of the different sizes of the dice can be accomplished by replacing the circular cutter shaft, the cross cutter shaft, and adjusting the thickness of the slicing.

Structural features and working principle

2.1 Structural features

2.1.1 The dicing machine is mainly composed of a frame, a casing for cutting materials, a pusher dial, a tool assembly, a transmission system and an electrical control system.

2.1.2 The dicing machine material must meet the food hygiene requirements. The frame, casing, dial, hopper and parts in contact with food are made of stainless steel.

2.2 Working principle

When the dicing machine is working, the pusher dial drives the object to be cut to rotate at a high speed, and uses the centrifugal force of the object to cut the object to be cut into pieces by means of a slicing knife (the vertical knife), and then cut into strips by a disc cutter, and The material to be cut is fed into the cross-cutting edge, and the transverse cutting blade is cut into the desired cube or cuboid.

Operational use

3.1 Preparation and inspection before use

3.1.1 Carefully check the dicing machine for missing, damaged or loose problems to ensure that the machine is in good condition.

3.1.2 Check if there is any foreign matter in the casing, and remove the foreign matter in the casing, otherwise the blade may be damaged.

3.1.3 Clean the operation site, check whether the power supply voltage matches the voltage used by the machine, and whether the grounding mark is reliably connected to the ground wire. Close the switch and press the "ON" button to check if the steering is correct (in the face of the pusher dial, the pusher dial rotates counterclockwise to the correct direction), otherwise, cut off the power supply to adjust the wiring.

3.1.4 Switch on the water source for use.

3.2 Operation and use

3.2.1 Firstly, the material to be cut should be washed and removed. If the material to be cut is mixed with sand and mud, the blade edge and the blade are easily damaged and blunt. The maximum cutting diameter of the material should not exceed 100mm. If it is larger than this diameter, it must be divided into blocks.

3.2.2 Press the start button motor to run. (The above cover is not pressed on the frame, the switch XK cannot be pressed, the line is blocked, the motor cannot run)

3.2.3 The material to be cut is uniformly and continuously fed into the hopper from the hopper. Under the action of the pusher dial, it is cut into the required thickness by the dicing knife, then cut into strips by the disc cutter, and finally Cut the knife into squares.

3.2.4 Adjustment of the dicing machine specification: It is changed by adjusting the slice thickness and replacing the disc cutter and the cross cutter.

3.25 When working on the machine, do not put your hands and other foreign objects into the casing to avoid danger.