Snack Chips,Puffed Food,Healthy Snacks Food,Cheese Flavoured Snacks Montreal Shantou Food Co., Ltd , https://www.montrealsnack.com
The use of straw returning machine technology
The use of straw returning machinery can significantly enhance soil health by increasing organic matter, improving fertility, and supporting long-term crop productivity. Proper operation and maintenance of these machines are essential to ensure efficiency and longevity. Below are key considerations when using a straw returning machine:
Before starting the machine, it is crucial to perform a thorough inspection. Check all connections for tightness, ensure that fasteners are secure, and verify that rotating parts move smoothly. Each tool holder and blade should be examined for damage or wear, and any faulty components must be repaired or replaced immediately. Also, check the tension of the V-belt and add lubricant as needed. Once everything is in order, run the machine for 3–5 minutes to confirm that all parts function properly.
During operation, make sure the tractor’s suspension rods are adjusted so that the machine remains level. The height of the depth limiter wheel should be set appropriately to maintain an ideal stubble height and prevent the blades from digging into the ground. Adjust your speed based on crop density, soil moisture, and firmness, and monitor the belt tension continuously. If the belt becomes too loose or too tight, adjust it promptly. When connecting to the power take-off (PTO), start at a low speed, gradually increasing to the rated engine speed before applying load. Avoid overloading the machine or starting with excessive force, as this may cause mechanical damage. Never allow unauthorized personnel near the machine during operation to ensure safety.
After finishing the task, clean the rotating parts and remove any soil buildup from inside the guard plates. Inspect and adjust any worn or loose components, and apply grease to all lubrication points. If the machine will not be used for an extended period, treat exposed parts with anti-corrosion measures. Blades should be oiled and stored in a dry, well-ventilated, and light-filled area. If stored outdoors, provide protection against rain and direct sunlight.
Common issues and their solutions include: poor crushing quality due to a loose belt, worn or damaged blades, excessive forward speed, heavy load, or reversed blade rotation—these should be addressed by adjusting or replacing the affected parts. A blocked feeding inlet may occur if the crop is too dense or the speed is too high; reducing the workload or slowing down the operation can resolve this. Strong vibrations could indicate a detached blade, loose bolts, incorrect yoke fork direction, or damaged bearings—each issue should be diagnosed and fixed accordingly. Excessive wear on the drive belt may result from improper tension, mismatched belt length, heavy loads, or blade contact with the ground; adjustments should be made based on the specific condition found.
Proper care and attention during operation not only extend the life of the equipment but also ensure optimal performance and safety. Always follow the manufacturer's guidelines and conduct regular maintenance to keep the machine in top working condition.