Installation and commissioning
1. In the vibrating feeder, it is used for batching and dosing to ensure uniform and stable feeding, and to prevent the material from self-flowing to be installed horizontally. For continuous feeding of general materials, it can be installed at 10° down. For viscous materials and materials with a large water content, they can be installed at a downward tilt of 15°.
2. The feeder after installation should have a horizontal clearance of 20mm, and the suspension device should be connected flexibly.
3. Before the empty test, all the bolts should be tightened once, especially the anchor bolts of the vibration motor. It should be tightened once for 3-5 hours.
4. When the test is started, the two vibration motors must rotate in the opposite direction, and the stability of current and noise should be stopped in time.
5. The motor bearing is filled with grease once every 2 months, and the lubricating oil should be filled once a month during the high temperature season.
Maintenance and requirements of GZG motor vibration feeder: 1. The feeder should always check the amplitude during the operation, the current of the vibration motor and the surface temperature of the motor. It is required to have a uniform amplitude before and after, and the vibration motor current is stable, such as If abnormal conditions are found, they should be stopped immediately. 2. The lubrication of the vibration motor bearing is the key to the normal operation of the whole feeder. During the use, the bearing should be filled with two-fluid molybdenum 2# grease regularly, once every two months, and every month during the high temperature season. Once, repair the motor once every six months and replace the internal bearing.

Operational regulations
1. Preparation before starting: (1) Read the duty record and deal with the remaining problems of the previous class: (2) Check and exclude any debris between the body and the chute, spring and bracket that affects the movement of the body; 3) Carefully check that all fasteners are completely tightened; (4) Check if the lubricating oil in the exciter is higher than the oil level; (5) Check if the transmission belt is good; if it is damaged, replace it; if there is oil Wipe it with a rag; (6) Check that the guard is good and remove it when it is found to be unsafe.
2. Start-up: (1) After inspection, the machine and transmission parts are normal and can be started; (2) the machine can only be started without load; (3) After starting, if abnormality is found, Stop immediately and wait until the abnormal conditions are identified and eliminated before starting again.
3. Use: (1) After the machine is stable and vibrated, it can be operated with materials; (2) The feeding should meet the requirements of the load test; (3) The stop should be carried out according to the process, and the material should be stopped or stopped or stopped. Continue to feed.

safety technology
1. Regular maintenance and overhaul is an important means to extend the service life of the machine and ensure normal work. Users should pay attention to it. For lubrication, the following points should be noted: (1) The machine is lubricated with thin oil splash. The lubricating oil should be determined according to the place of use and temperature conditions. Generally, gear oil is used. (2) The oil level in the shaker should be high. At the height of the oil mark (filled through the joint elbow), it must be replaced every 3-6 months. When changing the oil, clean the fuel tank, bearing raceway and gear surface with clean gasoline or kerosene.
2. Safety technology: (1) The operator of the machine must be educated by safety technology; (2) When operating, it is strictly forbidden to stand by the machine, touch the body by hand, adjust, clear, clean or repair; (3) Machine The equipment should be grounded, the wires should be reliably insulated, and installed in the snakeskin tube. Always check the motor wiring for wear and leakage.